Information Technology Reference
In-Depth Information
Table24-11 Cannot Configure the Configuration Server
Probable Cause
Possible Solution
This is the same
as the probable
cause in Table
24-7's contents
in rows 1
through 4.
Check the corresponding solutions in the same rows in Table 24-7.
The
configuration
server database
was not
configured.
Increase the timeout for the device on which you have configured
the configuration server.
The
configuration
server already
exists.
Using the CLI, remove the existing configuration server database.
The following is a sample configuration:
interface ATM0
mut 1500
atm pvc 1 0 5 qsaal
atm pvc 2 0 16 ilmi
atm ilmi-keepalive 5
lange config database xxxx
Remove this line:
Lange config database xxxx
ATM addresses
could not be
assigned to the
configuration
server.
Using the CLI, remove the ATM address association, if it already
exists. The following is a sample configuration:
interface ATM0
mtu 1500
atm pvc 1 0 5 qsaal
atm pvc 2 0 16 ilmi
atm ilmi-keepalive 5
lane config fixed-config-atm-address
lane config auto-config-atm-address
lane config config-atm-address
lane config database xxxx
Remove these lines:
lane config fixed-config-atm-address
lane config auto-config-atm-address
lane config config-atm-address
lane config database xxxx
