Adding Detail to Your Design - Autodesk Infraworks and Infraworks 360 Essentials - page 136

fIgure 4.19 A newly configured water area with adjusted Bank Width,
Buffer Width, and Water Level settings
18. Click Bookmarks on the Utility Bar to open the Bookmarks panel.
Click Bridge 1 to change your view. You should now see a bridge
crossing over a road and a river.
The river is currently displayed at the wrong width. It is set to the
default value that was applied at the time the river data source was
imported. In the next steps you will widen the river.
19. Click the river to select it. If the Properties panel is not already open
from the previous steps, right-click and select Properties.
20. In the Properties panel, change Buffer Width to 20 (6) . Check the box
next to Auto Update if it is not already checked.
The width of the river will double. You may have noticed that the
river is shown flowing right through a structure depicted on the
aerial photo.
21. Drag the vertex location grips on the river so that it passes along the
north side of the building, as shown in Figure 4.20.