Adding Detail to Your Design - Autodesk Infraworks and Infraworks 360 Essentials - page 135

fIgure 4.18 A newly created water area representing a pond
13. Click the pond to select it, right-click, and select Properties.
14. In the Properties panel, enter 25 (8) for Bank Width.
This will make the embankments less steep by allowing the tie in
from the pond elevation to the terrain to take place over a distance of
25 feet (8 meters).
15. Enter -25 (-8) for Buffer Width.
This will draw the pond edge inward by 25 feet to offset the additional
25 feet (8 meters) that it will occupy as a result of the last change.
16. Enter 79 0 (241) for Water Level.
This will elevate the pond so that it can be seen from the main
entrance.
17. Check the box next to Auto Update and press Esc to clear the selec-
tion of the water area. The pond should now look similar to what is
shown in Figure 4.19.