Adding Detail to Your Design - Autodesk Infraworks and Infraworks 360 Essentials - page 124

7. If the Create toolbar is not visible along the left side of your screen,
click the Create icon on the InfraWorks toolbar.

8. On the Create toolbar, click the Row of Trees icon.

9. In the Select Draw Style asset card, type hedge in the filter area.

10. Choose 3D Model > Vegetation > Oval Hedge from the list of styles.

11. Click a series of points along the eastern edge of the disturbed area
of the proposed industrial park, as indicated by the red dashed line in
Figure 4.9. Double-click the last point.

fIgure 4.9 The location of a proposed row of trees

12. Press Esc twice to exit the command.

▶ 13. Double-click one of the trees to select all of the trees in the row.

14. The program will zoom in to the tree that you've double-clicked as
part of the navigation behavior. Zoom out so that you can see all
the trees.

You may need to zoom
in to see the trees.

15. If you do not see gizmos for the row, right-click and select Edit.

16. Click the density slider; then hold and drag it to the right until the
tooltip reads approximately 95.

17. If some of the trees become unselected, double-click one of the
trees again so that all are selected.

18. Click the height gizmo and drag it upward until it reads about
200 ( 60 ).

19. Press Esc to clear the selection of the trees.