Graphics Programs Reference
In-Depth Information
Figure 6.156
The beveled
edges of the box
19. Select the box. Turn its display back to wireframe by going into the Attribute Editor
and, in the pCubeShape1 tab, turning off Shading under the Object Display
➔
Draw-
ing Overrides heading.
20. Select Edit Mesh
➔
Insert Edge Loop Tool
r
, and turn Auto Complete back on. In the
side panel, insert five horizontal edge loops as shown in Figure 6.157, starting with
the bottom one and going up. This gives you edges with which to create the wedge
cutout where the box is hinged and that gives you a little indentation where the lid
meets the box. You won't create a separate lid because you won't animate the box to
open or close, and you don't need to see the inside.
Insert these five edges
Figure 6.157
Insert these five
edge loops for the
lid of the box.
