Graphics Programs Reference
In-Depth Information
3. Repeat the previous procedures to close off the other three end cylinders to create
caps for both ends of both objects, as shown in Figure 5.31.
4. Connect and patch the end caps to their cylinders. To do this, you need to line up a
few new isoparms on the cylinders so you can stitch everything together properly.
Using the previous workf low, add new isoparms to the bottom cylinder, as shown in
Figure 5.32. (You may have to hide the end caps to create the isoparms on the cylin-
der. Select the end caps and use Display
➔
Hide
➔
Hide Selection. After you create the
isoparms, select Display
➔
Show
➔
Show All.)
Figure 5.31
End caps for the pump pieces
Figure 5.30
Scale down the outermost hull.
Figure 5.32
Add isoparms
as shown.
