Hatching - Introduction to AutoCAD 2011: 2D and 3D Design - page 169

Fig. 8.6 Select ANSI31 in the Hatch Creation/Pattern panel
Fig. 8.7 Set the Hatch Scale in the Hatch Creation/Properties panel
Fig. 8.8 Left-click Pick Points in the Hatch Creation/Boundaries panel
The Hatch and Gradient dialog
If the ribbon is not on screen, entering hatch or h at the command line
brings the Hatch and Gradient dialog to screen (Fig. 8.9). The method
of hatching given in the previous two examples is much the same whether