Graphics Reference
In-Depth Information
5.
Click on the label face and type-in 10 in the
Radius
box under the
Cross
Section
section. Click
OK
.
Embossing the bottom face
1.
Construct a parallel datum plane at 5 mm distance below the bottom face.
2.
Start a new sketch on the parallel datum plane.
3.
Activate the
Offset Curve
command and set the
Curve Rule
on the Top
Border Bar to
Connected Curves
.
4.
Click on the inner boundary edges of the bottom face.
5.
Type-in 10 in the
Distance
box and click the
Reverse Direction
button.
Click
OK
to project and offset the edges.
6.
Add 12 mm fillets to the corners and trim the unwanted edges portions. Fin-
ish the sketch.
