Integration of GPS with Other Sensors and Network Assistance - Understanding GPS: Principles and Applications - page 555

[14] Sennott, J. W., et al., “Navigation Receiver with Coupled Signal Tracking Channels,” U.S.

Patent 5,343,209, May 1992.

[15] Leimer, D., “Receiver Phase Noise Mitigation,” U.S. Patent 6,081,228, SiRF Technology,

September 1998.

[16] Beser, J., et al., “TRUNAV: A Low Cost Guidance/Navigation Unit Integrating a SAASM

Based GPS and MEMS in a Deeply Coupled Mechanization,” Proc. of The Institute of Nav-
igation ION-GPS 2002 , Vol. 24-27, Portland, OR, September 2002.

[17] Abbott, T., et al., Ultra-Tight GPS/IMU Coupling Method , The Aerospace Corporation,

TOR-2001(1590)-0846e, El Segundo, CA, April 10, 2001.

[18] Gautier, J. D., et al., “Using the GPS/INS Generalized Evaluation Tool (GIGET) for the

Comparison of Loosely Coupled, Tightly Coupled, and Ultra-Tightly Coupled Integrated
Navigation Systems,” Proc. of The Institute of Navigation 59th Annual Meeting , Albu-
querque, NM, June 2003.

[19] Gelb, A., et al., Multiple Input Describing Functions and Nonlinear System Design , New

York: McGraw-Hill, 1968.

[20] Manry, C. W., et al., “Advanced Mini Array Antenna Design Using High Fidelity Com-

puter Modeling and Simulations,” Proc. of The Institute of Navigation ION GPS-2000 ,
Salt Lake City, UT, September 2000, pp. 2485-2490.

[21] Tseng, H.-W., et al., “Test Results of a Dual Frequency (L1/L2) Small Controlled Reception

Pattern Antenna,” Proc. of The Institute of Navigation ION GPS-2002 , San Diego, CA,
January 2002.

[22] Kunysz, W., “Advanced Pinwheel—Compact Controlled Reception Pattern Antenna

(AP-CRPA) Designed for Interference and Multipath Mitigation,” Proc. of The Institute of
Navigation ION GPS-2002 , Portland, OR, September 2002.

[23] Yazdi, N., et al., “Micromachined Inertial Sensors,” Proc. of IEEE , Vol. 86, No. 8, August

1998, pp. 1640-1659.

[24] Peng, K. “A Vector-Based Gyro-Free Inertial Navigation System by Integrating Existing

Accelerometer Network in a Passenger Vehicle,” Proc. of IEEE Position Location and
Navigation Symposium (PLANS), Monterrey, CA, April 26-29, 2004, pp. 234-242.

[25] Schuler, A. R., “Measuring Rotational Motion with Linear Accelerometers,” IEEE Trans.

on Aerospace and Electronic Systems , Vol. AES-3, 1967, pp. 465-471.

[26] Weinburg, H., “MEMS Sensors Are Driving the Automotive Industry,” Sensors , Vol. 19,

No. 2, February 2002, pp. 36-41.

[27] Mostov, K. S., A. A. Soloviev, and T. J. Koo, “Accelerometer Based Gyro-Free Multi-Sensor

Generic Inertial Device for Automotive Applications,” Proc. of IEEE Conference on Intelli-
gent Transportation Systems , Boston, MA, November 1997, pp. 1047-1052.

[28] Chen, T. H., “Gyroscope Free Strapdown Inertial Measurement Unit by Six Linear Acceler-

ometers,” Journal of Guidance, Control, and Dynamics , Vol. 17, No. 2, 1994, pp.
286-290.

[29] Stephen, J., “Development of a Multi-Sensor GNSS Based Vehicle Navigation System,”

M.Sc. thesis, UCGE Report No. 20140, Department of Geomatics Engineering, University
of Calgary, Canada, August 2000.

[30] U.S. Department of Defense, “Micromachined System Opportunities,” a Department of

Defense Dual-Use Technology Industrial Assessment, 1995.

[31] Helsel, M., et al., “A Navigation Grade Micro-Machined Silicon Accelerometer,” Proc. of

IEEE Position Location and Navigation Symposium (PLANS), Las Vegas, NV, April
11-15, 1994, pp. 51-58.

[32] Lemkin, M. A., et al., “A Three Axis Surface Micromachined Sigma-Delta Accelerometer,

ISSCC Digest of Technical Papers , February 1997.

[33] Gustafson, D., et al., “A Micromechanical INS/GPS System for Guided Projectiles,” Proc.

ION 51st Annual Meeting, Colorado Springs, CO, June 5-7, 1995, pp. 439-444.