References - Computational Analysis and Design of Bridge Structures - page 586

Chapter 15
AASHTO, AASHTO LRFD Bridge Design Specifications, , 6th Edition, American
Association of State Highway and Transportation Officials, Washington, DC,
with 2013 Interim.
AASHTO, The Manual for Bridge Evaluation , 2nd Edition, American Association of State
Highway and Transportation Officials, Washington, DC, 2010 with 2012 Interim.
ANSYS ® , ANSYS Mechanical User Guide , ANSYS Inc., Canonsburg, PA, 2005.
Applied Research Associates, Inc. AT-Blast Version 2.2, 2004, http://www.ara.com/
products/AT-blast.htm.
ASCE/SEI7-10, Minimum Design Loads of Buildings and Other Structures , American
Society of Civil Engineers, Reston, VA, 2010
BEST Center, “TRAP (Truss Rating and Analysis Program) User's Manual,”
University of Maryland, College Park, MD, 2006.
Caltrans, “Memo to Designers 12-2: Guidelines for Identification of Steel Bridge
Members,” August 2004, http://www.dot.ca.gov/hq/esc/techpubs/manual/bridge-
manuals/bridge-memo-to-designer/page/Section%2012/12-2m.pdf.
FEMA-310, Handbook for the Seismic Evaluation of Buildings , Federal Emergency
Management Agency, Washington, DC, 1998.
FHWA/NSBA/HDR, “Steel Bridge Design Handbook FHWA-IF-12-052—Vol. 9:
Redundancy,” Federal Highway Administration, USDOT, November 2012,
http://www.fhwa.dot.gov/bridge/steel/pubs/if12052/volume09.pdf.
Fu, C.C., “Report on the Determination of Redundancy of the U.S. Bridge
Corporation Bridge 3000,” College Park, MD, 2000.
Fu, C.C. and Schelling, D.R., “Report on the Determination of Load and Fatigue
Capacity and Redundancy of the U.S. Bridge Corporation Bridge 2000/1000,”
College Park, MD, 1989.
Fu, C.C. and Schelling, D.R., “Report on the Determination of Load and Fatigue
Capacity and Redundancy of the U.S. Bridge Corporation Bridge 3000,”
College Park, MD, 1994.
Imhof, D, Middleton, C.R., and Palmer, A.C., “Redundancy Quantification in the Safety
Assessment of Existing Concrete Beam-and-Slab Bridges,” The 5th International
PhD Symposium in Civil Engineering , J. Walraven, J. Blaauwendraad, T. Scarpas
& B. Snijder (Eds.), 2004, Taylor & Francis Group, London, 2004, pp. 373-381.
Mahoney, E.E., “Analyzing the Effects of Blast Loads on Bridges using Probability,
Structural Analysis, and Performance Criteria,” Master Thesis (Advised by
Dr. C. C. Fu), University of Maryland, College Park, MD, August 2007.
NCHRP, “Report 403—A Redundancy in Highway Bridge Superstructures,”
NCHRP, Washington, DC, 1998.
NIST, “Report on Application of Seismic Rehabilitation,” National Institute of
Standards and Technology (NIST), September 2001.
Penn DOT. “Design Manual Part IV,” Harrisburg, PA, 2000, ftp://ftp.dot.state.pa.us/
public/PubsForms/Publications/PUB%2015M.pdf.
Razmi, J., Ladani, L., and Aggour, M.S., “Fatigue Crack Initiation and Propagation in
Piles of Integral Abutment Bridges,” Computer-Aided Civil and Infrastructure
Engineering , 28(5), 389-402, May 2013.
SAP2000 ® , “Integrated software for structural analysis & design,” Computers and Struc-
tures Inc., Berkeley, CA, 2007, http://www.csiamerica.com/products/sap2000.