Advanced Part Modeling Features - Inventor 2013 and Inventor LT 2013 Essentials - page 168

12. Click the Setbacks tab in the dialog box. Click Vertex 1 at the inter-
section of the Bottom, Front, and Left faces. Set the Setback values
for the three edges to 8.
13. Pick Click To Add below Vertex 1 to add another vertex at the inter-
section of the Bottom, Front, and Right faces. Set their values to 8 as
well, as shown in the dialog box in Figure 7.19, and then click OK.
FIGURE 7.18 Add a point along the edge to add
another radius.
FIGURE 7.19 The Setbacks tab of the Fillet dialog
box doesn't offer more options than the mini-toolbar but
can present them better.
Setbacks add a softer corner and are popular on items such as consumer prod-
ucts. By building the constant and variable radius features at once, setbacks can
be included.