Adding Detail to Your Design - Autodesk Infraworks and Infraworks 360 Essentials - page 149

4. Click Bookmarks on the Utility Bar to open the Bookmarks panel.
5. Click Industrial Park. InfraWorks will zoom to an area overlooking
the industrial park.
6. On the main toolbar, click Settings And Utilities to open the Settings
And Utilities toolbar along the left side of your screen.
7. On the Settings And Utilities toolbar, click Application Options.
8. In the Application Options dialog, click Navigation and then uncheck
the box next to Lock Mouse Navigation Above Ground, as you saw in
Figure 4.29.
9. Click 3D Graphics and then check the box next to Show Backfaces, as
you saw in Figure 4.30. Click OK.
10. On the main toolbar, click the Presentation icon to open the
Presentation toolbar long the left side of the screen.
11. On the Presentation toolbar, click Surface Opacity.
This will set the surface opacity setting to 50% so that you can see
through the terrain.
12. On the main toolbar, if the InfraWorks toolbar is not visible, click the
InfraWorks Home icon.
13. If the Create toolbar is not visible along the left side of your screen,
click the Create icon on the InfraWorks toolbar.
14. On the Create toolbar, click Pipeline Connector.
The Select Draw Style asset card will open.
15. In the Select Draw Style asset card, click Change Display Options
and select the top-left choice (Show Content Items With Text And
Thumbnail).
16. Use the Change Active Facets function to configure the Draw Style
panel so that only Pipe Connector styles are available.
17. Select Pipe Connector > Storm-Inlet.
18. Double-click the four locations shown in Figure 4.32. Don't worry
about being too accurate because you will learn techniques to edit
the locations of the pipeline connectors in the next section.