Graphics Programs Reference
In-Depth Information
Exercise 6.8: Create a table
In this exercise, you'll create a table for the tag labels you created and renumbered
in the previous exercise.
◀
If you haven't already
done so, download
and install the files for
Chapter 6 according to
the instructions in the
introduction.
1.
Open the drawing named
Create Table.dwg
located in the
Chapter 06
class data folder.
2.
Click the Jordan Court alignment, and then click Add Tables
➢
Add
Segments on the contextual ribbon tab.
3.
In the Alignment Table Creation dialog box, click the Select By Label
Or Style option.
4.
If you're unable to read the label style names, click and drag the
lower-right corner of the dialog box to increase its size. Then click
and drag the line between the Label Style Name and Selection Rule
column headings to widen the Label Style Name column. Repeat
these actions as needed until you can see the full names of the label
styles listed.
5.
Check the boxes in the Apply column for Alignment Curve: Circle Tag
and Alignment Line: Circle Tag.
6.
Click OK. Click a point in an open area of the drawing to insert
the table.
The table reflects the geometric data for the alignment (see
Figure 6.9).
7.
Save and close the drawing.
You can view the results of successfully completing this exercise by opening
Create Table - Complete.dwg
.
FiGuRE 6.9
An alignment segment table for
Jordan Court
