Designing Roads - Autodesk Roadway Design for Infraworks 360 Essentials - page 40

Exercise 2.2: Edit a Road Using Gizmos
In this exercise you will make some edits to the
bypass road by utilizing several different types
of gizmos. You will change the alignment of the
road and change the elevations of the road so
that there is enough vertical clearance to place a
bridge over an existing road.
If you are continuing from the previous
exercise, you can skip to step 3. Otherwise, if
you haven't already done so, go to the topic's
web page at www.sybex.com/go/
roadwayessentials and download the files for
Chapter 2. Unzip the files to the correct location
on your hard drive according to the instructions
in the introduction.
1. If it is not already open, launch InfraWorks
360.
2. On the Start Page, click Open and browse to
C:\InfraWorks Roadway
Essentials\Chapter 02\ . Click Ch02
Bimsville Roads.sqlite and click
Open.
3. Select the Ex_2_2 proposal. You should see
the model as it would appear at the end of
Exercise 2.1 with the new road section
created.
4. Restore the bookmark named PI-1.
5. Click the road to select it. If the PI gizmo
does not appear, right-click and select Edit.