Designing Roads - Autodesk Roadway Design for Infraworks 360 Essentials - page 41

If you still do not see a PI gizmo, set Edit
Mode to Geometry on the Road asset card.
6. Click and drag the PI gizmo to the center of
the green pushpin marker. Release the
gizmo when you are at the center of the
pushpin marker.
7. Restore the bookmark named Tangent
Gizmo.
8. Click and drag the light blue tangent gizmo
to the center of the green pushpin marker.
Release the gizmo when you are at the
center of the pushpin marker.
9. Restore the bookmark named PVI-1. Click
the PVI gizmo and then click the value for
Elevation in the tooltip. Edit the value so
that it reads 825 ( 250 ) and press Enter.
After a pause, a portion of the road will
move upward and should now appear as
shown in Figure 2-8 .
Figure 2-8: A view of the road after raising
a PVI