Information Technology Reference
In-Depth Information
Lab 2-1: Basic Static Route Configuration (2.8.1)
Upon completion of this lab, you will be able to
Cable a network according to the topology diagram
■
Erase the startup configuration and reload a router to the default state
■
Perform basic configuration tasks on a router
■
Interpret
debug ip routing
output
■
Configure and activate serial and Ethernet interfaces
■
Test connectivity
■
Gather information to discover causes for lack of connectivity between devices
■
Configure a static route using an intermediate address
■
Configure a static route using an exit interface
■
Compare a static route with intermediate address to a static route with exit interface
■
Configure a default static route
■
Configure a summary static route
■
Document the network implementation
■
Scenario
In this lab activity, you will create a network that is similar to the one shown in the topology diagram
in Figure 2-10. Begin by cabling the network as shown in Figure 2-10. You will then perform the ini-
tial router configurations required for connectivity. Use the IP addresses provided in Table 2-3 to
apply an addressing scheme to the network devices. After completing the basic configuration, test con-
nectivity between the devices on the network. First test the connections between directly connected
devices, and then test connectivity between devices that are not directly connected. Static routes must
be configured on the routers for end-to-end communication to take place between the network hosts.
You will configure the static routes that are needed to allow communication between the hosts. View
the routing table after each static route is added to observe how the routing table has changed.
Figure 2-10
Topology Diagram for Lab 2-1
172.16.1.0/24
PC2
Fa0/0
R2
S0/0/1
DCE
S0/0/0
172.16.2.0/24
192.168.1.0/24
172.16.3.0/24
192.168.2.0/24
S0/0/0
DCE
S0/0/1
Fa0/0
Fa0/0
R1
R3
PC1
PC3
