Static Routing - Routing Protocols and Concepts - page 99

Table 2-3 Addressing Table for Lab 2-1

Device Interface IP Address Subnet Mask Default Gateway

R1 Fa0/0 172.16.3.1 255.255.255.0 —

S0/0/0 172.16.2.1 255.255.255.0 —

R2 Fa0/0 172.16.1.1 255.255.255.0 —

S0/0/0 172.16.2.2 255.255.255.0 —

S0/0/1 192.168.1.2 255.255.255.0 —

R3 FA0/0 192.168.2.1 255.255.255.0 —

S0/0/1 192.168.1.1 255.255.255.0 —

PC1 NIC 172.16.3.10 255.255.255.0 172.16.3.1

PC2 NIC 172.16.1.10 255.255.255.0 172.16.1.1

PC3 NIC 192.168.2.10 255.255.255.0 192.168.2.1

Task 1: Cable, Erase, and Reload the Routers

Cable a network that is similar to the one in the topology diagram shown in Figure 2-10.

Step 1.

Clear the configuration on each router. Step 2.

Clear the configuration on each of the routers using the erase startup-config command
and then reload the routers. Answer no if asked to save changes.

Task 2: Perform Basic Router Configuration

Note: If you have difficulty with any of the commands in this task, see “Lab 1-1: Cabling a Network and Basic
Router Configuration (1.5.1).”

Use global configuration commands. Step 1.

On the routers, enter global configuration mode and configure the basic global configura-
tion commands, including the following:

hostname
no ip domain-lookup
enable secret

Configure the console and virtual terminal line passwords on each of the routers:

Step 2.

password
login

Add the logging synchronous command to the console and virtual terminal lines. Step 3.

This command is helpful in both lab and production environments and uses the following
syntax:

Router(config-line)# logging synchronous