Information Technology Reference
In-Depth Information
There is still a wedge that remains unfilled on the bottom. To fill this wedge, perform
the following steps:
1.
Hold the
Shift
key and select (
right-click
) the vertices of either edge of the
wedge to be filled.
2.
Three points will be selected.
3.
In the
3D View
panel menu, navigate to
Mesh
|
Faces
|
Make Edge/Face
or
press
F
to create a face from the selected points.
Detail work on the back
The back of the lion will be extruded and sealed in much the same way, but before
it can be there is some extra geometry from the scan that needs to be identified and
cleaned up first.
Zoom in on the posterior of the lion and locate the plate of points that are just
dangling there, barely attached to anything shown in the following screenshot.
Because more or less vertices may have been deleted when the part was trimmed
what is left may differ, but the spurious geometry should be there.
