Using Dynamic Blocks and Tables - AutoCAD 2011 and AutoCAD LT 2011: No Experience Required - page 482

FiGuRE 9.52 Deleting the block references with the Purge dialog box
4. With the Endpoint osnap and Polar Tracking running, click the Design
Center button on the View tab ➢ Palettes panel.
5. Click the Folders tab in the DesignCenter palette that opens. Use the
folder tree to browse to the DynDoor drawing you just saved in your
dataset directory.
The DynDoor file can also be found in the Chapter 9 download found
on the topic's website at http://sybex.com/go/autocad2011ner , or
the companion website at http://autocadner.com .
6. Expand the DynDoor drawing inside the DesignCenter palette to
select the Blocks option. Right-click on the A-DOOR block and select
Insert Block (see Figure 9.53).
The Insert dialog box opens where you can specify how you would
like the A-DOOR block inserted into your drawing.
7. Verify that the only check box selected within the Insert dialog box
is the Specify On-Screen check box under the Insertion Point group,
and click OK.
8. The A-DOOR dynamic door block appears attached to the cursor. Click
the lower-right corner of the back door opening to insert the block.
This is a 3 ′ -0 ″ (915 mm) door opening, so you don't need to modify
the block.