Graphics Programs Reference
In-Depth Information
FiGuRE 5.49
Geometric constraints inferred after drawing a line
Drawing the Stove Burners
The next step is to draw the circles that represent the burners. As with the
last exercise, we're not overly concerned about size at this point. Instead,
the focus will hinge around getting the geometry correct first, and then you'll come
back to further constrain the stove with dimensional constraints.
1.
Make sure
05A-FPLAY4.dwg
is open.
2.
Click the down arrow next to the Circle tool, found on the Home tab
➢
Draw panel, and look at the fly-out menu, as shown in Figure 5.50.
FiGuRE 5.50
T h e
CIRCLE
command's fly-out menu
Search WWH ::
Custom Search