Graphics Programs Reference
In-Depth Information
2.
Select SW Isometric from the 3D Views menu on the Viewport Controls (Figure 20.3).
You can also type
V
↵
SWISO
↵. This gives you a 3D view from the lower-left side of the
rectangles, as shown in the bottom image in Figure 20.4. Zoom out a bit to give yourself
some room to work.
3.
Select the two rectangles.
FIGURE 20.3
The SW Isometric
from the 3D Views
menu on the View-
port Controls
FIGURE 20.4
The chair seat and
back in the Plan
(top) and Isometric
(bottom) views
4.
In the upper part of the Tool Sets palette, click the Extrude tool.
5.
Position the cursor so that the direction of extrusion is upward, and then enter
3
↵ for a
height of 3˝. Metric users should make the height 7.6 cm.
