Graphics Programs Reference
In-Depth Information
First example - Polyline tool ( Fig. 2.23 )
In this example
enter
and
right-click
have not been included (Fig. 2.23).
Left -click
the
Polyline
tool icon. The command line shows:
Command:_pline Specify start point: 30,250
Current line width is 0
Specify next point or [Arc/Halfwidth/Length/Undo/
Width]: 230,250
Specify next point or [Arc/Close/Halfwidth/Length/
Undo/Width]: 230,120
Specify next point or [Arc/Close/Halfwidth/Length/
Undo/Width]: 30,120
Specify next point or [Arc/Close/Halfwidth/Length/
Undo/Width]: c (Close)
Command:
30,250
230,250
30,120
230,120
Fig. 2.23
First example - Polyline tool
N o t e s
1. Note the prompts -
Arc
for constructing pline arcs,
Close
to close
an outline,
Halfwidth
to halve the width of a wide pline,
Length
to
enter
the required length of a pline,
Undo
to undo the last pline
constructed
Width
to change the width of the pline.
2. Only the capital letter(s) of a prompt needs to be
entered
in upper or
lower case to make that prompt effective.
3. Other prompts will appear when the
Polyline
tool is in use as will be
shown in later examples.
Search WWH ::
Custom Search