Graphics Programs Reference
In-Depth Information
ThisopenstheJustificationEditor,shownin
Figure10.28
.
Here,thecontrol
point can be displayed, and the alignment along the selected route can be
selected byusing theAlignment Line button. Youcan choosejustification by
using one of the nine Justification control buttons. This can have significant
effects on your layout, so it is best to use this tool in small, easy-to-view
sections or 3D views.
Ductwork Justification
When you're adjusting the justification of ductwork, some duct fittings
(specifically duct transition fittings) have a tendency to move, shift, or
even change length along the duct they are on. Therefore, you must
allow for plenty of room along the duct run before and after any duct
transition fittings for which you may want to change justification. When
these objects have a slope applied, Revit is really re-creating that object
completely, which is why objects can shift when using this tool.
Figure 10.28
Duct Justification Editor
You can also change an entire duct run from one type of duct to another. In
previous versions, this involved multiple selections and filters. Now all the
userhastodoisselecttheductrun,asyoucanseein
Figure10.29
.Here,the
duct system has been selected, and the only proviso is that flexible ducts, air
terminals, and mechanical equipment are not in the selection set.
