Graphics Programs Reference
In-Depth Information
Figure 3-78
Boole connected to left side of the Computer table
Creating the Support for the Keyboard
In this section, you will create the support for the keyboard.
1. Press F4; the Front viewport is maximized. Choose the
Edges
tool from the Modes
Palette; the
Computer table
is displayed in the edges mode.
2. Right-click in the Front viewport
;
a shortcut menu is displayed. Choose
Knife
from the
shortcut menu; the
Knife
tool settings are displayed in the Attribute Manager. Next, se-
lect
Plane
from the
Mode
drop-down list and then clear the
Restrict to Selection
check
box. Select
X-Z
from the
Plane
drop-down list. Also, enter
2
in the
Cut
spinner.
3. Make sure the
Enable Snap
tool is deactivated in the Modes Palette. Next, click on the
edge, refer to Figure 3-80; two new edge loops are added to
Computer table.
Again, cre-
ate two more edge loops using the
Knife
tool.
Search WWH ::
Custom Search