Graphics Reference
In-Depth Information
The
Profile
command can also be used to draw arcs continuous with lines. Click the
Arc
icon on the
Profile
dialog to draw this type of arc. The figure below shows the procedure
to draw arcs connected to lines.
To delete a line, select it and press the
Delete
key. To select more than one line, click on
multiple line segments; the lines will be highlighted. You can also select multiple lines by
dragging a box from left to right. Press and hold the left mouse button and drag a box from
left to right; the lines inside the box boundary will be selected.
The Arc command
This command creates an arc using two methods:
Arc by 3 Points
and
Arc by Center and
Endpoints
.
The Arc by 3 Points method
This method creates an arc by defining its start, end, and radius. Activate the
Arc
command
(click
Home > Direct Sketch > Arc
on the ribbon). On the
Arc
dialog, click the
Arc by 3
Points
button, and then click to define the start point of the arc. Click again to define the
end point. After defining the start and end of the arc, you need to the define size and posi-
tion of the arc. Move the pointer and click to define the radius and position of the arc.