Stairs, Ramps, and Railings - Autodesk Revit Architecture 2015 Essentials - page 95

2. Click when you see the message 9 Risers Created, 9 Risers
Remaining. This will complete the first run of the stair. Since you
have not created enough risers to reach Level 2, you need to start
another run. Move the cursor over to the right until the temporary
dimension displays 5 ′ -0 ″ (1525 mm). Click again to start the next
run, and click to the right when you see 9 Risers Created, 0 Risers
Remaining (Figure 4.6).



A landing is automati-
cally created between
the two runs because
the Automatic Landing
setting on the Options
Bar setting was
checked. If needed,
you could uncheck this
parameter to avoid
automatically creating
a landing.

FiGure 4.6 Component stair run with landing

3. Select the Railings tool in the Tools panel of the ribbon. Specify
the Handrail - Rectangular type (Figure 4.7), and click OK to
close the dialog.
Revit Architecture will use this default handrail whenever you
create this stair, until you specify another type. The railing can be
edited, modified, or deleted at any time from the stair.

FiGure 4.7 Specifying the railing type

4. Click Finish Edit Mode to complete the component stair.