Graphics Programs Reference
In-Depth Information
The resulting stair is shown in the default 3D view in Figure 4.8.
FiGure 4.8 The resulting stair with railing
Now you'll create a second component stair to adjust some
additional parameters.
5. Start the Stair By Component tool again, but before you pick a point
to start the first run, choose the Location Line option from the
Options Bar.
6. Set the Location Line to Exterior Support: Left. This will align the
outside edge of the stair with your pick points, making it easier to
snap to existing geometry.
Each stair run compo-
nent can have its own
width using the Actual
Run Width parameter
on the Options Bar or
Properties palette. You
can enter this value
either before or after
placement.
7. For the start of the first run, click the endpoint of reference plane 1
where it meets the wall. Move to the right 6 -5 (955 mm), and click
again to complete this run.
Search WWH ::




Custom Search