Graphics Reference
In-Depth Information
To set the bottom falloff, drag the Start point down to a y value of 0 and the End point to a value of 15
mm. Activate the Scale tool again and scale x and z to 80%.
Now for the center inset area, you will use a slightly different technique:
1. Select two adjacent horizontal polygons in the middle of the bottle.
2. Press the L key to select the entire loop around the bottle.
3. Hold the Shift key and press the up-arrow key five times to increase the selection so that it covers the
label area of the bottle.
4. Set the Falloff to Selection.
5. In the Selection Falloff properties, set Steps to 1 and Shape to Linear.
6. Enable the Scale tool, and scale the x and z axes to 92.5%.
Figure 2-17:
The general bottle shape after using the Scale tool on three sections
