Hardware Reference
In-Depth Information
• 10 uF capacitor (
https://www.sparkfun.com/products/746
)
• 2 x 22 pF capacitors (
https://www.sparkfun.com/products/8571
)
• 10k ohm resistor (
https://www.sparkfun.com/products/8374
)
• 220 or 330 ohm resistor (
https://www.sparkfun.com/products/8377
)
• Green LED (
https://www.sparkfun.com/products/9650
)
• 16 MHz crystal clock (
https://www.sparkfun.com/products/536
)
• 2 x 1.5V AA batteries (
https://www.sparkfun.com/products/9100
)
• Breadboard (
https://www.sparkfun.com/products/12002
)
• Male/female jumper wires (
https://www.sparkfun.com/products/8431
)
On the software side, you will need to download the JeeLib Arduino library to enable
low-power operation of your system:
To install an Arduino library, simply place the library folder in the
/libraries
folder
of the main Arduino folder.
You will also need to download EAGLE to design your own
printed circuit board
(
PCB
) for this project. You can download it from the following link:
To design your own 3D-printed case, you can use OpenSCAD, which is a free design tool.
You can find it at the following address: