Cisco Equipment Operations - CCIE Routing and Switching Exam Certification Guide - page 73

System Configuration Dialog Example 3-8

Notice: NVRAM invalid, possibly due to write erase.
--- System Configuration Dialog ---

Would you like to enter the initial configuration dialog? [yes/no]: yes

At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.

Basic management setup configures only enough connectivity
for management of the system, extended setup will ask you
to configure each interface on the system

Would you like to enter basic management setup? [yes/no]: yes

Configuring global parameters:

Enter host name [Router]: router1

The enable secret is a password used to protect access to
privileged EXEC and configuration modes. This password, after
entered, becomes encrypted in the configuration.
Enter enable secret:
% No defaulting allowed
Enter enable secret: cisco

The enable password is used when you do not specify an
enable secret password, with some older software versions, and
some boot images.
Enter enable password: ins

The virtual terminal password is used to protect
access to the router over a network interface.
Enter virtual terminal password: cisco
Configure SNMP Network Management? [yes]: n

Current interface summary

Any interface listed with OK? value "NO" does not have a valid configuration

Interface IP-Address OK? Method Status Protocol
Ethernet0 unassigned NO unset up up

FR-ATM20 unassigned NO unset initializing down

Serial0 unassigned NO unset up up

Serial1 unassigned NO unset up up

continues