Information Technology Reference
In-Depth Information
Which switch command's output is similar to the output of the router
show ip interface
brief
command?
3
a.
show vlan interface brief
b.
show port status
c.
show port interface
d.
show ip vlan
When booting a router, you reach the following message:
4
--- System Configuration Dialog ---
Would you like to enter the initial configuration dialog? [yes/no]:
What might have caused this to occur?
a. The router's configuration register was set to 0x2142.
b. A
write erase
command was performed prior to reboot.
c. The running configuration was deleted from NVRAM.
d. Answer a or b.
After entering the
debug ip rip
command, no messages appear on your Telnet screen.
What is one likely cause?
5
a. OSPF is also running.
b. The console port is disabled.
c. The
terminal monitor
command needs to be configured.
d. RIP broadcasts every 30 seconds.
Which command can be used to verify the configuration register setting for the next
reload?
6
a.
show hardw
b.
show version
c.
show config-reg
d. Answer a or b
Where is the startup configuration usually stored?
7
a. slot0 of the flash card
b. NVRAM
c. Active RAM after bootup
d. ROM
Search WWH ::
Custom Search