Information Technology Reference
In-Depth Information
What could have caused this to occur?
a. The router's configuration register was set to 0x2142.
b. A
write erase
command was performed prior to reboot.
c. The running configuration was deleted from NVRAM.
Answer a or b.
After entering the
debug ip rip
command, no messages appear on your Telnet screen.
What is one likely cause?
5
a. OSPF is also running.
b. The console port is disabled.
c. The
terminal monitor
command needs to be configured.
d. RIP broadcasts every 30 seconds.
Which command verifies the configuration register setting for the next reload?
6
a.
show hardw
b.
show version
c.
show config-reg
d. Answer a or b
Where is the startup configuration usually stored?
7
a. slot0 of the flash card
b. NVRAM
c. Active RAM after bootup
d. ROM
Which statement is correct?
8
a. The
enable secret
command overrides the
password
password
command.
b. The
enable secret
command overrides the
enable
password
command.
c. The
enable secret
command overrides the
service password-encryption
command.
d. The
enable secret
command sets the console password.
Search WWH ::
Custom Search