Working with Non–Autodesk Inventor Data - Inventor 2013 and Inventor LT 2013 Essentials - page 314

FIGURE 14.19 Adding the hot water output to the heater
10. Rotate the model to see the top, left, and front faces of the ViewCube.
11. Start the Electrical Connector tool from the MEP Author panel.
12. Click the curved edge on the side of the model opposite the water
pipe connectors.
13. Set System Type to Power Balanced, change Number Of Poles to 3
using the drop-down as shown in Figure 14.20, and click OK.
14. Click the Export Building Components tool on the Manage panel.
FIGURE 14.20 Adding the electrical connection to the
product