Graphics Programs Reference
In-Depth Information
15. Drag the red arrow at the end of the bolt until it shows you are placing
an M10 35 bolt (Figure 4.14).
16. Click OK to finish the tool and OK again to approve the creation of a file.
17. Double-click the red part to see that a tapped hole has been added to it.
18. Click the Return tool at the end of the Ribbon to return to the assembly.
FIGURE 4.13 Filtering fasteners based on standards
makes selection easier.
FIGURE 4.14 In a bolted connection,
you can drag the hole depth and bolt length.
Placing fasteners using this tool saves time over placing holes in advance and
using the Content Center. If the assembly changes, you might have to edit the
bolted connection and click OK to update it. I will review Design Accelerator
tools in Chapter 8.
Search WWH ::




Custom Search