Information Technology Reference
In-Depth Information
Table17-2
Dialup Client Receives No exec Prompt (continued)
Possible Causes
Suggested Actions
Modem speed
setting is not
locked
1.
Use the
show line
exec command on the access server or
router. The output for the auxiliary port should indicate the
currently configured Tx and Rx speeds.
For an explanation of the output of the
show
line command, see
the section “Using
debug
Commands,” earlier in this chapter.
If the line is not configured to the correct speed, use the
speed
line configuration command to set the line speed on the
access server or router line. Set the value to the highest speed
in common between the modem and the access server or
router port.
2.
