Information Technology Reference
In-Depth Information
Table13-3 VINES: Client on Serverless Network Cannot Connect to Server over PSN (continued)
Possible Problem
Solution
PVC
4
is not set up
Use the
show running-config
privileged exec command to
view the configuration of the router. Make sure a PVC is set
up between the routers on each side of the PSN using the
x25
pvc n vines address
interface configuration command.
1.
If the command is not present, add it to the configuration.
2.
VINES
broadcasts are not
forwarded across
the PSN
1.
Use the
show running-config
command to examine the
configuration of the router. Make sure the
vines propagate
interface configuration command is configured on the serial
interface of the router that provides the serverless
packet-switched node service.
2.
If the command is not present, add it to the configuration.
VINES
broadcasts not
forwarded to all
router interfaces
1.
Use the
show running-config
privileged exec command to
view the router configuration. Check whether the
vines
serverless broadcast
interface configuration command is
configured on the router.
2.
If the command is not present, configure the router using the
vines serverless broadcast
command. This command
configures the router to always flood VINES broadcasts on
all interfaces.
Note:
The
vines serverless broadcast
command is enabled by
default in Cisco IOS Release 10.3 and later.
1.
DLCI = Data Link Connection Identifier
2.
IETF = Internet Engineering Task Force
3.
CSA = compression service adapter
4.
PVC = permanent virtual circuit
