Information Technology Reference
In-Depth Information
Possible Problem
Solution
Misconfigured
source-bridge
command
1.
For each router on which NetBIOS name caching is enabled,
use the
show source-bridge
command to obtain the version
of the remote connection. The value specified should be 2 or
3. If the value is 1, connections will not get through, and you
must modify your configuration.
continues
Misconfigured
source-bridge
command
Example:
The following is sample output from the
show source-bridge
command:
Router#
show source-bridge
Local Interfaces: receive transmit
srn bn trn r p s n max hops
cnt
cnt drops
TR0
5 1
10 *
*
7
39:1002
23:62923
Ring Group 10:
This peer: TCP 150.136.92.92
Maximum output TCP queue length, per peer: 100
Peers: state lv pkts_rx
pkts_tx expl_gn drops TCP
TCP 150.136.92.92
-
2
0
0
0 0 0
TCP 150.136.93.93
open
2*
18
18
3 0 0
Rings:
bn: 1 rn: 5 local ma: 4000.3080.844b
TokenRing0 fwd: 18
bn: 1 rn: 2 remote ma: 4000.3080.8473 TCP
150.136.93.93 fwd: 36
Explorers: ------- input -------
-------
output -------
spanning all-rings total spanning
all-rings total
TR0
0
3
3
3
5 8
Router#
2.
If the router is running a software release prior to Cisco IOS
Release 10.0, specify either version 2 or version 3 in the
source-bridge remote-peer
interface configuration
command. The syntax is as follows:
source-bridge remote-peer
ring-group tcp ip-address
[
lf size
]
[
local-ack
] [
priority
] [
version number
]
If the router is running Cisco IOS Release 10.0 or later, the
specification of a version is ignored.
For more information, refer to the Cisco IOS
Bridging and IBM
Networking Configuration Guide
and
Bridging and IBM
Networking Command Reference
.
Translational Bridging: Client Cannot Connect to Server
Symptom:
Clients cannot communicate over a router configured as a translational bridge.
