Information Technology Reference
In-Depth Information
Table10-3
RSRB: Host Cannot Connect to Server (Peers Not Open) (continued)
Possible Problem
Solution
End system that is
not generating
explorer traffic
1.
Use the
show source-bridge
privileged exec command to
see whether the explorer count is incrementing.
2.
If the explorer count is not incrementing, use the
show
running-config
privileged exec command to view the router
configuration. Check for a source-bridge spanning interface
configuration command on the local and remote routers.
3.
If the
source-bridge spanning
command is not configured
on the routers, configure it on the interfaces connecting the
local and remote SRBs. This command is required if the end
system is using single-route explorers. The command syntax
is as follows:
source-bridge spanning
bridge-group
[
path-cost
path-cost
]
Syntax description:
•
bridge-group
—Number in the range 1 to 9 that you choose
to refer to a particular group of bridged interfaces.
•
path-cost
—(Optional) Path cost for a specified interface.
•
path-cost
—(Optional) Path cost for the interface. The valid
range is 0 to 65535.
Example:
The following example adds Token Ring 0 to bridge group 1 and
assigns a path cost of 12 to Token Ring 0:
interface tokenring 0
source-bridge spanning 1 path-cost 12
