Information Technology Reference
In-Depth Information
Table8-8
IPX Enhanced IGRP: No Connectivity over IPX Enhanced IGRP Router (continued)
Possible Problem
Solution
Routes are not
redistributed
properly.
Route redistribution between IPX Enhanced IGRP autonomous
systems and between Enhanced IGRP and other routing
protocols is not enabled by default. You must manually configure
redistribution between different autonomous systems or routing
protocols.
1.
Use the
show running-config
privileged exec command on
any routers that border two Enhanced IGRP autonomous
systems. Look for
redistribute
protocol
IPX-router
configuration command entries.
2.
If the command is not present, you must enter the
appropriate
redistribute
protocol
command to allow route
redistribution between different autonomous systems or
routing protocols.
For detailed information on configuring route redistribution, see
the
Network Protocols Configuration Guide, Part 1.
Routers are not
establishing
neighbors
properly.
For information on troubleshooting this problem, see the section
“IPX Enhanced IGRP: Routers Not Establishing Neighbors,”
next.
Router are not
propagating
SAPs.
For information on troubleshooting this problem, refer to the
section “IPX Enhanced IGRP: SAP Updates Not Propagated by
Router,” later in this chapter.
IPX Enhanced IGRP: Routers Not Establishing Neighbors
Symptom
: IPX Enhanced IGRP routers do not establish neighbors properly. Routers that are known to
be connected do not appear in the neighbor table.
Procedures for troubleshooting IPX Enhanced IGRP problems not specific to establishing
neighbors are described in the section “IPX Enhanced IGRP: No Connectivity over IPX
Enhanced IGRP Router,” earlier in this chapter.
Note
