Information Technology Reference
In-Depth Information
Table8-3
Novell IPX: Client Cannot Connect to Server over PSN (continued)
Possible Problem
Solution
Misconfigured
LMI
5
type (Frame
Relay only)
Use the
debug frame-relay lmi
privileged exec command to
see the LMI type being used by the Frame Relay switch.
1.
The LMI type is determined by your Frame Relay provider.
Make sure that you use the LMI type specified by the
provider.
2.
Full Frame Relay
broadcast queue
(Frame Relay
only)
This problem is most likely to occur on the hub router in a Frame
Relay hub-and-spoke topology.
1.
Use the
show interfaces
privileged exec command to check
for dropped Frame Relay broadcast frames.
2.
If the number of drops on the broadcast queue is excessively
high, increase the size of the queue using the
frame-relay
broadcast-queue size byte-rate packet-rate
interface
configuration command.
Command syntax:
frame-relay broadcast-queue
size byte-rate packet-rate
Command syntax:
size
—Number of packets to be held in the broadcast queue. The
default is 64 packets.
byte-rate
—Maximum number of bytes to be transmitted per
second. The default is 256,000 bytes per second.
packet-rate
—Maximum number of packets to be transmitted per
second. The default is 36 packets per second.
