Graphics Programs Reference
In-Depth Information
FIG. 7.35
Create two cuts to remove the pole on the foot's arch.
FIG. 7.36
Add a new edge loop around the base of the leg.
●
Simply
Extrude
the three polygons in the ankle area, pulling out the ankle
shape ( Figure 7.37 ).
●
Repeat this for the inner ankle, extruding the ankle out of the leg
( Figure 7.38 ).
(Tip: Remember, your inner ankle is slightly higher than the outer one.)
●
Finally, delete the two upper edges from the extrude (Figure 7.39). This will
soften the upper parts of the ankle.