Graphics Programs Reference
In-Depth Information
Fig. 3-8
This dialog is
from ProfileMaker Pro. It
provides a similar feedback
but also provides a read-
out for desired and current
color temperature and an
indicator when the user
has successfully adjusted
the RGB controls with a
green checkbox.
nuts accuracy, you'll be using a smart display and none of these arrow
and setting issues will be presented to you anyway.
The software and instrument work in tandem. The process usually
requires the user to alter controls on the display while getting some kind
of feedback from the software until the calibration target is achieved.
With most third-party solutions, the software will expect you to set the
display using the OSD (on-screen display). The problem is OSD often will
appear dead-center right in front of the instrument. This makes it impos-
sible to work properly. Some displays will allow you to move the OSD
location. If your display does not it will be necessary to dismiss the ODS
each time the instrument takes a measurement. This can be frustrating
and there isn't much you can do about it except be patient. In this situ-
ation some packages allow you to move the position of the patches being
measured. Although not optimal, this will lower your level of frustration.
If possible, move the patches and instrument back to the center of the
display for the remainder of the calibration process.
When the calibration and profile process is complete, usually you'll
be asked to name the profile, after which the software will save it in the
right location based on your operating system. It doesn't really matter
what name you use for the profile. I highly recommend you use the same
name for the same target each time. This will overwrite the previous
profile. There's no reason to keep old display profiles floating around. The
most current profile reflects the most current calibration. The most
important thing to do now is keep your hands off the display controls
