Graphics Reference
In-Depth Information
Locate where the filament guide tube attaches to the top of the extruder. You
must remove the filament guide tube from the extruder. To remove the tube,
gently pull the tube out of the hole in the top of the extruder (see Figure 6-12 ).
Figure 6-12. Detaching the tube
Free the end of the MakerBot PLA Filament from the filament spool. Feed the
end of the MakerBot PLA Filament into the end of the guide tube connected
to the back of the MakerBot Replicator 2. Thread the MakerBot PLA Filament
through the guide tube until the end appears near the extruder. Figure 6-13
shows how to feed it through.
Figure 6-13. Feed the filament through
Search WWH ::




Custom Search