Graphics Programs Reference
In-Depth Information
7.
Double-click the top box, then hold Shift and select the next two
boxes, leaving the fourth box unselected. Press Cmd+C and Cmd+V to
make a copy of the three boxes in place. Drag the reference point at the
center of the selection to the intersection of the guides and type
100%
in the Width box and
-100%
in the Height box. Figure 10.10 shows the
result. Press Enter twice to exit Free Transform Path mode and to
dismiss the paths.
O
Using a negative
scale factor flips the
design over.
FIGURe 10.10
Flipping paths vertically
8.
Drag a window around the five rightmost boxes (excluding the top and
bottom boxes) to select them. Press Cmd+C, Cmd+V, and Cmd+T to
duplicate the boxes and enter Free Transform Path mode. Drag the ref-
erence point to the intersection of the guides. Type
-100%
in the Width
box and
100%
in the Height box and press Enter. Figure 10.11 shows
the resulting symmetrical design. Deselect the Rectangle 1 layer.
