First Print with the Simple - 3D Printing: Build your Own 3D Printer and Print your own 3D Objects - page 85

Figure 5.5 Confirm that your 3D printer is connected to Repetier.
Note
Consult the “Simple Getting Started Guide” at http://printrbot.com/sup-
port/instructions-and-guides/ for troubleshooting help with the Simple
and Repetier software. You might also want to visit printrbottalk.com
and post a question if you can't find an answer to your technical issue.
Get the Hot End Up to Proper Temperature
The hot end must get up to the proper temperature for melting the filament. The
Printrbot Simple “Getting Started Guide” will have you configure the temperature
to 195 degrees Fahrenheit (refer back to Chapter 4 ) , and that's the temperature you
will see used for this chapter's print job.
To get the hot end heating up, change to the Print Panel in Repetier. On the right
side of the screen in Repetier, I click the Print Panel button shown in Figure 5.6
and then click the Heat On button.