Graphics Reference
In-Depth Information
•
The center of the new circle will be specifi ed, then type in the radius.
You will see the following:
°
If you hover over a point for couple of seconds to produce the infi nite line
and then discover that it is not the desired point, simply go to the same point
again, and hover over it for a couple of seconds to disable it.
DRAWING USING OSNAP AND OTRACK
Exercise 7
1. Start AutoCAD 2010.
2. Open the fi le
Exercise_07.dwg
.
3. Make sure that
Snap
and
Grid
are both turned off.
4. Using
OSNAP
, switch on
Endpoint
.
5.
Draw the fi rst arc between points (1) and (2) using
Start
,
End
,
Angle
, where
point (1) is the start point and the angle = -90.
6.
Draw the second arc between points (3) and (4) using
Start
,
End
,
Direction
,
where point (3) is the start point and the direction = 270.