Graphics Reference
In-Depth Information
Select arc or polyline arc segment:
(Select the desired arc)
Specify arc length dimension location, or [Mtext/Text/Angle/
Partial/Leader]:
(Specify the location of the dimension block)
°
There are two steps to follow:
Select the desired arc.
Specify the location of the dimension block.
The following is the result:
°
°
The options
Mtext
,
Text
, and
Angle
—which are available to the
Arc Length
command—were discussed in the
Linear
command section.
Partial
If you want
Arc Length
to measure part of the arc and not the entire arc,
specify the two points on the arc. The result looks something like this:
°
Leader
To add a leader, see the following example:
°
9.18 THE RADIUS COMMAND
°
The
Radius
command is used to put a radius dimension on an arc and/or
a circle.
To start the
Radius
command, make sure you are in the
Annotate
tab on
the
Ribbon
, and, using the
Dimensions
panel, click the
Radius
button.
°