Graphics Reference
In-Depth Information
5. Using the
Make Block
command, create a block using the following
information:
a. Block name = Door
b. Specify the designated base point.
c. Delete the shape after the creation of the block.
d. Block unit = Inches
e. Scale uniformly = off, Allow exploding = on
f. Description = Door to be used inside the building. Refer to the door
table.
g. Open in block editor = off
6. Save the fi le and close it.
6.3 INSERTING BLOCKS
°
Once you create a block, you can use it in your drawing as many times as
you wish.
When inserting a block into your drawing, consider the following
guidelines:
Set the desired layer to be current.
Prepare the drawing to accommodate the block (e.g., fi nish the door
openings before inserting the door block).
After you consider all of these guidelines, issue the command.
°
°
