Designing Gravity Pipe Networks - AutoCAD Civil 3D 2015 Essentials - page 261

1. Open the drawing named Drawing Pipe Networks in Profile
View.dwg located in the Chapter 14 class data folder.
2. In the left viewport, select the new storm manhole near the western
corner of the Common Area, and then click Draw Parts In Profile on
the ribbon.
3. In the top-right viewport, click one of the grid lines of the Jordan
Court profile view. The manhole is drawn in the profile view. Press
Esc to clear the selection.
4. Click the pipe that connects to the manhole from the southeast.
5. Click Draw Parts In Profile on the ribbon, and again click the grid of
the Jordan Court profile view.
6. Repeat steps 2 and 3 for the inlet located north of station
2+40.42 (0+073.28).
7. Repeat steps 2 and 3 for the pipe that begins at station
2+40.42 (0+073.28) and ends at station 5+50 (0+170).
8. Repeat steps 2 and 3 for the inlet located to the west of station
5+50 (0+170).
Now there are two pipes and three structures drawn in the profile
view (see Figure 14.10).
FiGuRE 14.10 Two pipes and three structures drawn in a profile view
9. Save and close the drawing.
You can view the results of successfully completing this exercise by
opening Drawing Pipe Networks in Profile View - Complete.dwg.