Graphics Programs Reference
In-Depth Information
▶
To choose a structure, select Rectangular Junction Structure
NF (SI)
➢
Curb Inlet from the first drop-down list.
▶
To choose a pipe, select Concrete Pipe (SI)
➢
15 Inch (400mm)
Concrete Pipe from the second drop-down list.
The Network Layout Tools toolbar should appear as shown in
Figure 14.8.
5.
Right-click the Osnap icon at the bottom of the screen, and then click
Object Snap Settings.
If the Osnap icon isn't
visible, turn it on using
the status bar custom-
ization menu, accessed
by clicking the icon in
the bottom-right corner
of your screen.
FiGuRE 14.8
The Network Layout Tools toolbar after selecting the
structure and pipe
◀
6.
On the Object Snap tab of the Drafting Settings dialog box, do the
following:
These settings will cause
the Center object snap
to be used each time you
click a point in the draw-
ing. This will help you do
the next few steps a bit
more quickly.
a.
Check the box next to Object Snap On (F3).
b.
Click Clear All.
c.
Check the box next to Center.
d.
Click OK.
◀
7.
Click the center of the red circle to the east of station 5+50 (0+170).
As you create each
pipe and structure,
you can click over
to the bottom-right
viewport at any time to
see the system being
constructed in 3D. Then
you can click back to
plan view to continue
with the actual steps.
8.
Click the center of the red circle to the west of station 5+50 (0+170).
9.
Pan northward until you can see the two red circles at the low point of
station 2+40.42 (0+073.28). Click the circle to the south of the road.
10.
On the Network Layout Tools toolbar, choose the pipe Concrete
Pipe (SI)
➢
18 Inch (450mm) Concrete Pipe.
11.
Click the center of the red circle located north of station 2+40.42
(0+073.28).
◀
12.
On the Network Layout Tools toolbar, do the following:
a.
Choose the structure Cylindrical Junction Structure
NF (SI)
➢
Storm Manhole.
b.
Choose the pipe Concrete Pipe (SI)
➢
24 Inch (600mm)
Concrete Pipe.
13.
Click the red circle located at the western corner of the common area.
